Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfgwis
To configure an out-of-service VISM card to the in-service state, use the cnfgwis command in the VoIP
switching/trunking operating mode.
Syntax Description
This command has no arguments or keywords.
Command Modes
VoIP switching/trunking
Usage Guidelines
This command causes an RSIP notification to be sent to the call agent.
Examples
The following example shows that the current VISM card is configured to the in-service state:
cnfgwis
The VISM card prompt terminates with an a to indicate the in-service state:
NODENAME.1.9.VISM8.a
Related Commands
Command
cnfgwoos
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfgwis
Description
Configures an in-service VISM card to the out-of-service state.
Cisco VISM Installation and Configuration Guide
cnfgwis
5-151
Advertisement
Table of Contents
