Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 414

delrudptrunk
delrudptrunk
To delete an ISDN PRI backhaul Reliable User Datagram Protocol (RUDP) session that is associated
with a Link Access Protocol D channel (LAPD), use the delrudptrunk command in the VoIP
switching/trunking operating mode.
Syntax Description
session-num
Command Modes VoIP switching/trunking
Usage Guidelines
You must use the dellapdtrunk command to delete the LAPD trunk before you delete the RUDP trunk.
Examples The following example shows that the ISDN PRI backhaul RUDP session number 51, which is
associated with an LAPD, is deleted:
delrudptrunk 51
Related Commands Command
addlapdtrunk
addrtpcon
addrudptrunk
clrrtpcnt
cnflapdtrunkpvc
cnflntrunkcond
cnfrtpcon
cnfrudptrunkrmtip Modifies the remote IP address of VISM used in the ISDN PRI backhaul RUDP
dellapdtrunk
delrtpcon
dsplapd
dsplapdtrunkpvc
dsplapdtrunks
dsprtpcnt
dsprtpcon
Cisco VISM Installation and Configuration Guide
5-270
delrudptrunk session-num
Identifying session number in the range from 1 to 64.
Description
Adds an LAPD trunk to a specific VISM card line.
Adds a static RTP VoIP trunking connection.
Adds an ISDN PRI backhaul RUDP session for an LAPD trunk connection.
Clears the RTP counters (statistics) for a specific static RTP connection.
Assigns the PVC trunk type that carries LAPD messages for the current VISM
card.
Enables or disables line conditioning on a VISM card line if a network alarm
is encountered.
Modifies an existing static RTP VoIP trunking connection.
trunk for a specified session.
Deletes an LAPD configured line.
Deletes a static RTP VoIP trunking connection.
Displays data about an LAPD.
Displays the assigned PVC trunk type that carries LAPD trunk messages for
the current VISM card.
Displays the configuration data of all LAPD trunks.
Displays the bearer counters (statistics) for a specified RTP VoIP trunking
connection.
Displays the configuration data of a specified static RTP VoIP trunking
connection.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands