Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 536

dspnwcot
dspnwcot
To display the status—enabled or disabled—of the gateway-initiated network continuity test
configuration for VISM, use the dspnwcot command in the VoIP switching/trunking and switched
AAL2 PVC operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that VISM is configured for a gateway-initiated network continuity test:
dspnwcot
GW Initiated Network COT: On
Related Commands Command
cnfco4timer
cnfnwcot
dspco4timer
dspvismparam
Cisco VISM Installation and Configuration Guide
5-392
dspnwcot
Description
Configures the bearer continuity test CO4 timer value.
Configures VISM for a gateway-initiated network continuity test.
Displays the bearer continuity test CO4 timer value.
Displays the current VISM card configuration.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands