Table of Contents
Advertisement
Chapter 5
CLI Commands
dncon
To configure a specified connection down, preventing traffic from being passed to the specified
connection, use the dncon command in the VoIP switching/trunking, switched AAL1 SVC, switched
AAL2 SVC, switched AAL2 PVC, AAL2 trunking, VoIP and switched ATM AAL1 SVC operating
modes.
Syntax Description
lcn
Command Modes
VoIP switching/trunking, switched AAL1 SVC, switched AAL2 SVC, switched AAL2 PVC, AAL2
trunking, VoIP and switched ATM AAL1 SVC
Usage Guidelines
If you use this command and the previous channel state is active (up), a connection down trap is sent.
Examples
The following example shows that connection 188 is configured to be administratively down and no
traffic is passed to it:
dncon 188
Related Commands
Command
dspcon
upcon
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dncon lcn
The logical channel number. It can be in the range from 131 to 510.
Description
Displays the parameters for a specified channel.
Configures a specified connection up, allowing traffic to be passed to the specified
connection.
Cisco VISM Installation and Configuration Guide
dncon
5-279
Advertisement
Table of Contents
