Table of Contents
Advertisement
Chapter 5
CLI Commands
dsplndsp
To display the digital signal processor (DSP) data for a specified T1 or E1 line, use the dsplndsp
command in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
line-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the DSP data for line 1 are displayed:
dsplndsp 1
VismLineNum:
ECANEnable:
ECANReenable:
ToneDisable:
MaximumTail:
ResidualEcho:
VoiceDetection:
VAD and ECAN apply to the VoIP switching/trunking operating mode only.
Note
Related Commands
Command
addln
delln
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dsplndsp line-num
Line number for which you want to display the DSP data. It can be in the range from
1 to 8.
1
enable
ReenableOnModemData
G.165
32 milliseconds
ComfortNoise
Enable
Description
Adds a T1 or E1 line to a VISM card.
Deletes a T1 or E1 line from a VISM card.
Cisco VISM Installation and Configuration Guide
dsplndsp
5-365
Advertisement
Table of Contents
