Table of Contents
Advertisement
Chapter 5
CLI Commands
dspxgcppeers
To display all the User Datagram Protocol (UDP) peer ports used by the Simple Gateway Control
Protocol (SGCP) or the Media Gateway Control Protocol (MGCP), use the dspxgcppeers command in
the VoIP switching/trunking operating mode.
Syntax Description
This command has no arguments or keywords.
Command Modes
VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the UDP ports used by xGCP are displayed:
dspxgcppeers
mgcNumber
-----------
1
1
Related Commands
Command
cnfxgcppeer
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspxgcppeers
protocolNumber
-------------
1
2
Description
Configures the UDP port number used to send gateway-initiated messages to the call
agent.
portNumber
----------
2064
2427
Cisco VISM Installation and Configuration Guide
dspxgcppeers
5-481
Advertisement
Table of Contents
