Configuring VISM Features
Complete the following steps to:
Add and configure your eight T1 or E1 line ports on the VISM back card.
•
Add and configure your eight T1 and E1 line ports on the SRM card if your application requires bulk
•
distribution.
You can configure the DS0s on a line after a line is added and configured.
Note
Step 1
Type the addln command, a line-num argument value, and press Enter to add a line to your VISM card.
Specify the line-num argument value in the range 1 to 8.
The VISM card prompt and line number are displayed.
Step 2
Type the cnfln command, line-num, line-code, line-length, clock-source, line-type, and
loopback-detection argument values, and press Enter to specify the operating parameters for the line
added in
•
line-num: In the range from 1 to 8
•
line-code:
–
–
–
line-length:
•
–
–
–
•
clock-source:
–
–
line-type:
•
–
–
–
–
–
–
–
–
–
loopback-detection:
•
–
–
Cisco VISM Installation and Configuration Guide
4-12
Step
1. Specify the arguments with the following values:
2 = B8ZS for T1 lines
3 = HDB3 for E1 lines
4 = AMI for T1 or E1 lines
8 = AX-SMB-8E1 and AX-R-SMB-8E1 back card types
9 = AX-RJ48-8E1 and AX-R-RJ48-8E1 back card types
10 to 15 = T1 back cards, where 10 = 0 to 131 ft, 11 = 131 to 162 ft, 12 = 262 to 393 ft, 13 =
393 to 524 ft, 14 = 524 to 655 ft, and 15 = over 655 ft
1 = Loop clock
2 = Local clock
1 = DSx1ESF
2 = DSx1D4
3 = E1
4 = E1CRC
5 = E1MF
6 = E1MFCRC
7 = E1 Clear
8 =
9 =
1 = Disabled
2 = Enabled
Chapter 4
Configuring VISM Features
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004