Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 188

addsesset
addsesset
To add a PRI backhaul session set between a VISM card and a call agent, use the addsesset command
in the VoIP switching/trunking and switched AAL2 PVC operating modes.
Syntax Description
set-num
fault-tol-enable
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines The set-num argument value must be set to 1.
Examples
The following example shows that the PRI backhaul session set number 1 is added between a VISM card
and a call agent:
addsesset 1
Related Commands Command
delsesset
Cisco VISM Installation and Configuration Guide
5-44
addsesset set-num fault-tol-enable
In the range from 1 to 16.
Currently, only session set number 1 is supported.
Note
Enable or disables fault tolerance. It can be one of the following values:
• 1 = Yes
• 2 = No
Description
Deletes a PRI backhaul session set.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands