Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfconvcci
To associate a virtual circuit connection identifier (VCCI) and a remote address with an LCN, use the
cnfconvcci in the switched AAL2 PVC operating mode.
Syntax Description
lcn
vcci-num
addr-type
fe-addr
Command Modes
Switched AAL2 PVC
Usage Guidelines
The VCCI number does not need to be unique for the not applicable (1) address type, and the far end
address is not used.
The combination of VCCI number and far end address must be unique for the following address types:
•
•
•
The VCCI number must be unique for the unspecified (5) address type, even though the far end address
is not used.
Examples
The following example shows that LCN 131 is not associated with a VCCI or far end address:
cnfconvcci 131 1
Related Commands
Command
dspcon
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfconvcci lcn vcci-num addr-type |fe-addr|
Logical channel number of the connection; in the range from 131 to 510.
VCCI number. It can be in the range from 0 to 65535.
Address type of the VCCI. It can be one of the following values:
•
1 = Not applicable
Note
This address type disassociates a VCCI, far end address type, and far end
address from an LCN.
•
2 = NSAP (20-byte hexadecimal address)
3 = E.164 (1- to 15-byte decimal address)
•
4 = Gateway ID (1- to 64-byte ASCII character address)
•
5 = Unspecified
•
(Optional) Far end IP address. This argument is optional if the addr-type value = 1 or
5. This argument is mandatory if the addr-type value = 2, 3, or 4.
NSAP (2)
E.164 (3)
Gateway ID (4)
Description
Displays the parameters for a specified LCN.
Cisco VISM Installation and Configuration Guide
cnfconvcci
5-133
Advertisement
Table of Contents
