Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 485

Chapter 5 CLI Commands
dspdpvcoamparams
To display the transmitted and received permanent virtual circuit (PVC) operations, administration, and
maintenance (OAM) cell parameters, use the dspdpvcoamparams command in the VoIP
switching/trunking operating mode.
Syntax Description
This command has no arguments or keywords.
Command Modes VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the transmitted and received PVC OAM cell parameters are
displayed:
dspdpvcoamparams
OAM Cell Gap
OAM Cell Retry Count
OAM Cell Recovery Count: 5
Related Commands Command
cnfdpvcoamparams
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspdpvcoamparams
: 500ms
: 3
Description
Configures the transmitted and received PVC OAM cell parameters.
Cisco VISM Installation and Configuration Guide
dspdpvcoamparams
5-341