Table of Contents
Advertisement
Chapter 5
CLI Commands
dsprsvpif
To display the Resource Reservation Protocol (RSVP) status of a specified connection, use the dsprsvpif
command in the VoIP switching/trunking and VoIP and switched ATM AAL1 SVC operating modes.
Syntax Description
lcn
Command Modes
VoIP switching/trunking and VoIP and switched ATM AAL1 SVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the RSVP status of LCN 142 is displayed:
dsprsvpif 142
Interface:
RSVP:
Refresh Interval: 45 sec
Refresh Multiple: 7
Related Commands
Command
cnfrsvp
cnfrsvprefreshmiss
dsprsvpreq
dsprsvpreqs
dsprsvpresv
dsprsvpresvs
dsprsvpsender
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dsprsvpif lcn
Logical channel number of the connection for which you want to display the
RSVP status; in the range from 131 to 510.
142
Enable
Description
Configures RSVP for a specified connection.
Configures the number of times VISM waits for a missed RSVP minimum
refresh message for a specified connection.
Displays the data associated with a specified RSVP request.
Displays all RSVP-known requests on the current VISM card.
Displays all data associated with an RSVP bandwidth reservation.
Displays all incoming RSVP-known reservations on the current VISM card.
Displays all data associated with a specified RSVP path state.
Cisco VISM Installation and Configuration Guide
dsprsvpif
5-397
Advertisement
Table of Contents
