Table of Contents
Advertisement
addmgcgrpentry
addmgcgrpentry
To configure a call agent as part of a media gateway controller (MGC) redundancy group and assign a
priority value for the call agent, use the addmgcgrpentry command in the VoIP switching/trunking and
switched AAL2 PVC operating modes.
Syntax Description
mgc-group
mgc-num
mgc-preference
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
You must add a call agent to a call agent redundancy group regardless of the absence of additional call
agents in the redundancy group.
Use the dspmgcgrpparams command to verify call agent redundancy group configuration data.
Examples
The following example shows that call agent redundancy group number 1 is configured with the call
agent number 5, and assigned a priority level of 3:
addmgcgrpentry 1 5 3
Related Commands
Command
addmgcgrpprotocol
cnfmgcgrpentry
cnfmgcgrpparam
cnfsrcppeer
cnfsrcppeergrpparam
delmgcgrpentry
delmgcgrpprotocol
dspmgcgrpparams
dspmgcgrpprotocols
dspmgcgrps
dspsrcppeergrpparams
Cisco VISM Installation and Configuration Guide
5-30
addmgcgrpentry mgc-group mgc-num mgc-preference
Call agent redundancy group number. It can be in the range from 1 to 8.
Call agent identification number. It can be in the range from 1 to 8.
Call agent preference value—The preference of the MGC within the
group. It can be in the range from 1 (highest) to 8. (Default = 1)
Description
Associates a call agent redundancy group to a gateway control protocol.
Modifies the call agent priority level of a call agent within a call agent
redundancy group.
Modifies a call agent redundancy group state change notification policy
and priority level.
Configures the SRCP parameters when SRCP is the selected protocol for
communication between the VISM card and call agent.
Modifies the SRCP heartbeat interval and maximum UDP size for a
specified call agent redundancy group.
Deletes a call agent from a call agent redundancy group.
Deletes an MGCP from a specified call agent redundancy group.
Displays all configured call agent redundancy group parameters.
Displays all configured call agent redundancy group protocols.
Displays all configured call agent redundancy groups.
Displays the SRCP parameters for all call agent redundancy groups that
have SRCP added.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
