addxgcppersistevt
addxgcppersistevt
To add persistent xGCP (various gateway control protocol) events, use the addxgcppersistevt command
in the VoIP switching/trunking and switched AAL2 PVC operating modes.
Syntax Description
event-num
pkg-event
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
This command notifies the call agent of the specified event without the need for a xGCP notification
request. There are no persistent xGCP events by default. Only valid xGCP strings (described in the
pkg-event syntax description list) can be configured with this command.
Examples
The following example shows that the persistent event index number 1 is added for the voiceband data
package:
addxgcppersistevt 1 g/vbd
Cisco VISM Installation and Configuration Guide
5-48
addxgcppersistevt event-num pkg-event
The persistent event index package event number in the range from 1 to 64.
The xGCP package and event string listed as persistent. It can be one of the
following:
r/co3 = VISM initiated AAL2 type 3 packet (CO3) network continuity test
•
r/co4 = Network continuity test detect
•
•
g/ft = Fax tone
•
g/mt = Modem tone
•
g/vbd = Voiceband data
•
g/vbdt = Voiceband data termination
•
l/hu, bl/hu = On hook
l/hd, blhd = Off hook
•
ms/ans, dt/ans, md/ans, mo/ans = Answer
•
ms/sup, dt/sup, md/sup = Setup
•
ms/rel, dt/rel, md/rel, mo/rel = Release
•
•
ms/rtc, dt/rlc, md/rlc, mo/rlc = Release complete
•
ms/res, dt/res, md/res = Resume
•
ms/sus, dt/sus, md/sus = Suspend
•
md/awk = Acknowledgment wink
•
mo/rbz = Reverse make busy
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands