Table of Contents
Advertisement
Chapter 5
CLI Commands
dsplntoneplan
To display the tone plan configuration of a specified VISM card line, use the dsplntoneplan command
in the VoIP switching/trunking and switched AAL2 PVC operating modes.
Syntax Description
line-num
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the tone plan configuration for the current VISM card line number 8
is displayed:
dsplntoneplan 8
LineNum
Dsx1TonePlanRegion :singapore
Dsx1TonePlanVersion:11
Related Commands
Command
addtoneplan
cnflnringback
cnflntoneplan
cnflntonetimeout
dellntoneplan
deltoneplan
dsplnringback
dsplntonetimeout
dsptonebuiltinplans Displays all preconfigured (built-in) tone plans on the current VISM card.
dsptoneplan
dsptoneplans
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dsplntoneplan line-num
Line number for which you want to display the tone plan configuration. It can
be in the range from 1 to 8.
:8
Description
Adds a tone plan to the current VISM card.
Configures the ringback tone method for a specified line on the current VISM
card.
Assigns a tone plan to a specified VISM card line.
Modifies the timeout periods of all call progress tones supported by VISM on
a specified VISM card line.
Deletes the tone plan configuration of a specified VISM card line.
Deletes a previously added tone plan from the current VISM card.
Displays the ringback tone method for a specified line on the current VISM
card.
Displays the configured timeout periods for all call progress tones of a
specified VISM card line.
Displays the tone configuration of a specified tone plan—either a
preconfigured (built-in) or user-added tone plan.
Displays the tone configuration of all tone plans—either preconfigured
(built-in) or user-added tone plans.
Cisco VISM Installation and Configuration Guide
dsplntoneplan
5-375
Advertisement
Table of Contents
