Table of Contents
Advertisement
Chapter 5
CLI Commands
delmgcgrpentry
To delete a call agent from a call agent redundancy group, use the delmgcgrpentry command in the VoIP
switching/trunking and switched AAL2 PVC operating modes.
Syntax Description
mgc-group
mgc-num
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
The last call agent within a call agent redundancy group cannot be deleted if there are protocols
associated with the call agent redundancy group.
A call agent redundancy group is deleted when the last call agent has been deleted from a group.
Use the dspmgcgrpparams CLI to verify your configuration.
Examples
The following example shows that call agent number 2 is deleted from call agent redundancy group
number 1:
delmgcgrpentry 1 2
Related Commands
Command
addmgcgrpentry
addmgcgrpprotocol
cnfmgcgrpparam
cnfmgcgrpentry
cnfsrcppeer
cnfsrcppeergrpparam
delmgcgrpprotocol
dspmgcgrpparams
dspmgcgrpprotocols
dspmgcgrps
dspsrcppeergrpparams
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
delmgcgrpentry mgc-group mgc-num
Call agent redundancy group number. It can be in the range from 1 to 8.
Call agent identification number. It can be in the range from 1 to 8.
Description
Configures call agents as part of an MGC redundancy group and assigns a
priority value for a call agent.
Associates a call agent redundancy group to a gateway control protocol.
Modifies a call agent redundancy group state change notification policy
and priority level.
Modifies the call agent priority level of a call agent within a call agent
redundancy group.
Configures the SRCP parameters when SRCP is the selected protocol for
communication between the VISM card and call agent.
Modifies the SRCP heartbeat interval and maximum UDP size for a
specified call agent redundancy group.
Deletes an MGCP from a specified call agent redundancy group.
Displays all configured call agent redundancy group parameters.
Displays all configured call agent redundancy group protocols.
Displays all configured call agent redundancy groups.
Displays the SRCP parameters for all call agent redundancy groups that
have SRCP added.
Cisco VISM Installation and Configuration Guide
delmgcgrpentry
5-263
Advertisement
Table of Contents
