Table of Contents
Advertisement
Chapter 5
CLI Commands
delendptloop
To take an endpoint out of the loopback condition, use the delendptloop command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
endpt-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the loopback state is deleted from endpoint number 120:
delendptloop 120
Related Commands
Command
addendptloop
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
delendptloop endpt-num
Endpoint number which is to be deleted. It can be a value from one of the following
ranges:
•
For template number 1:
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
•
For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
•
For template number 3:
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
For template number 4:
•
For VISM-PR, from 1 to 144
–
Description
Places an endpoint in the loopback condition in the TDM direction.
Cisco VISM Installation and Configuration Guide
delendptloop
5-253
Advertisement
Table of Contents
