cnfsesstatetmout
cnfsesstatetmout
To configure the number of milliseconds that VISM waits for a transfer state before executing an auto
reset, use the cnfsesstatetmout command in the VoIP switching/trunking operating mode.
Syntax Description
session-num
tstate-tout
Command Modes
VoIP switching/trunking
Usage Guidelines
Use this command for a previously added PRI backhaul session.
Examples
The following example shows that session number 2 is configured with a 500-ms transfer state timeout:
cnfsesstatetmout 2 500
Related Commands
Command
cnfsesack
cnfsesmaxreset
cnfsesmaxseg
cnfsesoutofseq
cnfsesport
cnfsesretrans
cnfsessyncatmps
Cisco VISM Installation and Configuration Guide
5-212
cnfsesstatetmout session-num tstate-tout
Identifying session number in the range from 1 to 64.
Transfer state timeout. The maximum number of milliseconds that VISM
waits for a transfer state before executing an auto reset. It can be in the range
from 0 to 65535. (Default = 2000)
Description
Configures the timeout period before sending an acknowledgment, and the
maximum number of acknowledgments that can be accumulated.
Configures the maximum number of resets that a VISM card performs before
a connection is reset.
Configures the maximum segment size, in octets, that can be received by a
VISM card after sending a synchronize message.
Configures the maximum number of out-of-sequence packets that can be
accumulated before sending an EACK packet.
Configures the port numbers of a previously added PRI backhaul session.
Configures the timeout period for unacknowledged packets and number of
retransmissions.
Configures the maximum number of call agent synchronization attempts.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands