Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfdisctimers
To specify the wait delay times for the disconnected procedure, restart in progress command—initial,
minimum, and maximum timer values—use the cnfdisctimers command in the VoIP switching/trunking,
switched AAL1 SVC, switched AAL2 SVC, switched AAL2 PVC, AAL2 trunking, VoIP and switched
ATM AAL1 SVC operating modes.
Syntax Description
init-wait-time
min-wait-time
max-wait-time
Command Modes
VoIP switching/trunking, switched AAL1 SVC, switched AAL2 SVC, switched AAL2 PVC, AAL2
trunking, VoIP and switched ATM AAL1 SVC
Usage Guidelines
You must use the cnfmgcgrpprotocol command and select the disconnect type method for Restart in
Progress commands before you can use this command.
Examples
The following example shows that an initial disconnect waiting time of 30 seconds, a minimum
disconnect waiting time of 0 seconds, and a maximum disconnect waiting time of 120 seconds is
configured for the current VISM card:
cnfdisctimers 30 0 120
Related Commands
Command
addmgcgrpprotocol
cnfmgcgrpprotocol
cnfxgcppeer
delmgcgrpprotocol
dspdisctimers
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfdisctimers init-wait-time min-wait-time max-wait-time
Initial disconnect waiting delay time (defined in seconds). In the range from 1 to
100.
Minimum disconnect waiting delay time (defined in seconds). In the range from 0
to 100.
Maximum disconnect waiting delay time (defined in seconds). In the range from 1
to 5000.
Description
Associates a call agent redundancy group to a gateway control protocol.
Configures call agent group protocol data.
Configures the UDP port number used to send gateway-initiated messages to
the call agent.
Deletes an MGCP from a specified call agent redundancy group.
Displays the Restart in Progress command disconnect type method wait
delay times.
Cisco VISM Installation and Configuration Guide
cnfdisctimers
5-135
Advertisement
Table of Contents
