Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfsesoutofseq
To configure the maximum number of out-of-sequence packets that can be accumulated before sending
an EACK packet, use the cnfsesoutofseq command in the VoIP switching/trunking operating mode.
Syntax Description
session-num
max-seq-pkts
Command Modes
VoIP switching/trunking
Usage Guidelines
Use this command for a previously added PRI backhaul session.
Examples
The following example shows that a maximum of 10 out-of-sequence packets can be accumulated before
an EACK packet is transmitted for session number 2:
cnfsesoutofseq 2 10
Related Commands
Command
cnfsesack
cnfsesmaxreset
cnfsesmaxseg
cnfsesnullsegtmout
cnfsesport
cnfsesretrans
cnfsesstatetmout
cnfsessyncatmps
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfsesoutofseq session-num max-seq-pkts
Identifying session number in the range from 1 to 64.
The maximum number of out-of-sequence packets that can be accumulated
before an EACK packet is transmitted. It can be in the range from 0 to 255.
Note
Description
Configures the timeout period before sending an acknowledgment, and the
maximum number of acknowledgments that can be accumulated.
Configures the maximum number of resets that a VISM card performs before
a connection is reset.
Configures the maximum segment size, in octets, that can be received by a
VISM card after sending a synchronize message.
Configures the idle time before sending a null segment.
Configures the port numbers of a previously added PRI backhaul session.
Configures the timeout period for unacknowledged packets and the number
of retransmissions.
Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
Configures the maximum number of call agent synchronization attempts.
If you specify 0, a DACK message is sent immediately upon
receiving an out-of-sequence packet.
Cisco VISM Installation and Configuration Guide
cnfsesoutofseq
5-209
Advertisement
Table of Contents
