Table of Contents
Advertisement
clralm
clralm
To clear alarms on a specific VISM card line, use the clralm command in the VoIP switching/trunking,
switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
-ds1
line-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
This command clears alarms caused by the collection of statistical data. Alarms caused by network
failure cannot be cleared by using this command. For example, an alarm caused by a collection of bipolar
errors can be cleared, but an alarm caused by a line failure cannot. Alarms that occur after you execute
this command are not affected.
Examples
The following example shows that any alarms caused by statistical data are cleared from line 1:
clralm -ds1 1
Related Commands
Command
clralms
dspalm
dspalms
Cisco VISM Installation and Configuration Guide
5-52
clralm -ds1 line-num
The mandatory line-num argument identifier.
Line number in which to clear alarms. In the range from 1 to 8.
Description
Clears alarms on a VISM card.
Displays the alarms associated with a specified line.
Displays all alarms for the selected line type (T1 or E1) on a card.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
