Table of Contents
Advertisement
cnfds0musicthreshold
cnfds0musicthreshold
To configure the music on-hold threshold for a specified DS0, use the cnfds0musicthreshold command
in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
line-num
ds0-num
music-thresh
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the VISM card line number 2, DS0 number 30 is configured with a
–45 dB music on-hold threshold value:
cnfds0musicthreshold 2 30 -45
Related Commands
Command
cnflnmusicthreshold
cnfmusicthreshold
dspds0musicthreshold
dsplnmusicthreshold
dspmusicthreshold
Cisco VISM Installation and Configuration Guide
5-144
cnfds0musicthreshold line-num ds0-num music-thresh
Line number for which you want to configure the music on-hold threshold.
In the range from 1 to 8.
DS0 number for which you want to configure the music on-hold threshold.
It can be a value from one of the following ranges:
•
•
Music on-hold threshold (defined in decibels). It can be in the range from
–70 to –30.
Description
Configures the music on-hold threshold for all DS0s on a specified line.
Configures the music on-hold threshold value for the current VISM card.
Displays the music on-hold threshold value for a specified DS0.
Displays the music on-hold threshold values for the DS0s on a specified
line.
Displays the music on-hold threshold values for the current VISM card.
1 to 24 for T1 lines
1 to 31 for E1 lines
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5
CLI Commands
Advertisement
Table of Contents
