Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 570

dspsesset
dspsesset
To display configuration data about a specified Primary Rate Interface (PRI) backhaul session set, use
the dspsesset command in the VoIP switching/trunking and switched AAL2 PVC operating modes.
Syntax Description
set-num
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples The following example shows that the configuration data for PRI backhaul session number 1 is
displayed:
dspsesset 1
vismSessionSetNum:
vismSessionSetState:
vismSessionSetTotalGrps:
vismSessionSetActiveGrp:
vismSessionSetFaultTolerant:
vismSessionSetSwitchFails:
vismSessionSetSwitchSucesses: 0
Related Commands Command
addsesset
delsesset
Cisco VISM Installation and Configuration Guide
5-426
dspsesset set-num
In the range from 1 to 16.
Currently, only session set number 1 is supported.
Note
Description
Adds a PRI backhaul session set between a VISM card and a call agent.
Deletes a PRI backhaul session set.
1
Idle
2
0
FT
0
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands