Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 471

Chapter 5 CLI Commands
dspcodecjtrdelays
To display the configured codec jitter delay modes and associated jitter initial delays, use the
dspcodecjtrdelays command in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the configured codec jitter delay modes and associated jitter initial
delays are displayed:
dspcodecjtrdelays
Codec
-----
G7.11u
.
.
.
Related Commands Command
cnfcodecjtrdelay
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspcodecjtrdelays
JitterDelayMode JitterInitialDelay
--------------- ------------------
fixed 100
Description
Configures the jitter delay mode and initial delay value for a specified codec.
Cisco VISM Installation and Configuration Guide
dspcodecjtrdelays
5-327