Table of Contents
Advertisement
Chapter 4
Configuring VISM Features
Type the cnfvbdpol command, carrier-loss-pol and cac-reject-pol argument values, and press Enter to
Step 4
specify card level default policies for a fax/modem carrier loss and a fax/modem CAC failure. Specify
the arguments with the following values:
•
•
You have completed configuring CAC on your VISM card. Proceed to the
Service" section on page
Placing the VISM Card In Service
Type the cnfgwis command and press Enter to place the VISM card in service. The VISM card prompt
terminates with an a to indicate the in-service state:
NODENAME.1.9.VISM8.a
Placing the VISM Card Out of Service
Type the cnfgwoos command, a oos-method argument value, and press Enter to place the VISM card
out of service. Specify the oos-method argument with one of the following values:
•
•
The VISM card prompt terminates with an s to indicate the out-of-service (standby) state:
NODENAME.1.9.VISM8.s
Configuring the TDM Side
You must perform the following tasks to configure the TDM side of your networking application:
1.
2.
3.
Configuring T1 and E1 Lines
This section deals with the configuration of the eight physical T1/E1 ports on the VISM back card or, if
bulk distribution is used, the equivalent ports being fed from the Service Resource Module (SRM) card.
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
carrier-loss-pol:
1 = Revert to the previous codec.
–
2 = Maintain the upspeed codec.
–
cac-reject-pol:
–
1 = Delete the connection.
2 = Maintain the connection and revert to the previous codec.
–
4-11.
2—Forceful
3—Graceful
Configure T1 and E1 lines.
Configure VISM card clocking.
Configure DS0 channels.
"Placing the VISM Card In
Cisco VISM Installation and Configuration Guide
Configuring VISM Features
4-11
Advertisement
Table of Contents
