Table of Contents
Advertisement
pinglndsp
pinglndsp
To display the digital signal processor (DSP) configuration data and status for all endpoints on a
specified line, use the pinglndsp command in the VoIP switching/trunking, switched AAL2 PVC, and
AAL2 trunking operating modes.
Syntax Description
line-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the DSP configuration data and status for the VISM card line 1 is
displayed:
pinglndsp 1
Related Commands
Command
dsplndsp
Cisco VISM Installation and Configuration Guide
5-486
pinglndsp line-num
Line number for the DSPs you want to display configuration data and status. It can
be a value in the range from 1 to 8.
Description
Displays the DSP information for a specified VISM card line.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
