Table of Contents
Advertisement
Chapter 5
CLI Commands
cnflnsig
To configure the signaling mode for a VISM card line, use the cnflnsig command in the AAL2 trunking
operating mode.
Syntax Description
line-num
line-signal-type
Command Modes
AAL2 trunking
Usage Guidelines
You are required to confirm your entry when using this command to ensure that the signaling type is not
changed while endpoints are configured for the line indicated by the line-num argument.
This command is not allowed when CIDs or CCS channels are present.
You must configure the line type as either E1MF or E1MFCRC for E1 lines; otherwise, this command
is invalid and does not process.
Examples
The following example shows that line 3 is configured for CCS:
cnflnsig 3 2
Related Commands
Command
dspln
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnflnsig line-num line-signal-type
Line number you want to bring to the out-of-service state. In the range from 1 to
8.
Signaling type of the line. It can be one of the following values:
1 = Channel associated signaling (CAS)
2 = Common channel signaling (CCS)
3 = No signaling
Description
Displays the characteristics of a VISM card line.
Cisco VISM Installation and Configuration Guide
cnflnsig
5-173
Advertisement
Table of Contents
