Table of Contents
Advertisement
Chapter 5
CLI Commands
dspsrcpretry
To display the VISM card level Simple Resource Control Protocol (SRCP) retransmission
parameters—maximum number of retransmission attempts, minimum timeout, and maximum
timeout—use the dspsrcpretry command in the VoIP switching/trunking and switched AAL2 PVC
operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the VISM card level SRCP retransmission parameters are displayed:
dspsrcpretry
Min Request Timeout :
Retry Count
Max Request Timeout :
Related Commands
Command
dspsrcpcnt
dspsrcpcnts
dspsrcppeer
dspsrcppeers
dspsrcpport
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspsrcpretry
500
:
3
500
Description
Displays the SRCP message counters (statistics) for a specified call agent.
Displays SRCP message counters (statistics) for all known call agents.
Displays the peer configuration data for a specified SRCP peer (call agent).
Displays the peer configuration data for all known SRCP peers (call agents).
Displays the local UDP port number used by the SRCP on VISM.
Cisco VISM Installation and Configuration Guide
dspsrcpretry
5-435
Advertisement
Table of Contents
