Table of Contents
Advertisement
Chapter 5
CLI Commands
cnflnmusicthreshold
To configure the music on-hold threshold for all DS0s on a specified line, use the cnflnmusicthreshold
command in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
line-num
music-thresh
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the VISM card line number 3 DS0s are configured with –45 dB music
on-hold threshold:
cnflnmusicthreshold 3 -45
Related Commands
Command
cnfds0musicthreshold
cnfmusicthreshold
dspds0musicthreshold
dsplnmusicthreshold
dspmusicthreshold
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnflnmusicthreshold line-num music-thresh
Line number for which you want to configure the music on-hold threshold.
In the range from 1 to 8.
Music on-hold threshold (defined in decibels). It can be in the range from
–70 to –30.
Description
Configures the music on-hold threshold for a specified DS0.
Configures the music on-hold threshold value for the current VISM card.
Displays the music on-hold threshold value for a specified DS0.
Displays the music on-hold threshold values for the DS0s on a specified
line.
Displays the music on-hold threshold values for the current VISM card.
Cisco VISM Installation and Configuration Guide
cnflnmusicthreshold
5-169
Advertisement
Table of Contents
