Table of Contents
Advertisement
cnfconcacpol
cnfconcacpol
To configure the policies for fax/modem upspeed connection admission control (CAC) failure and
fax/modem carrier loss for calls added to a particular IP or AAL2 LCN, use the cnfconcacpol command
in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
lcn
carrier-loss-pol
cac-reject-pol
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
If you select 3 (unspecified) for the carrier-loss-pol or cac-reject-pol argument values, the card level
default are used.
Examples
The following example shows that LCN 131 is configured with a carrier loss policy of 1 (if carrier is lost,
the LCN reverts to the previous codec) and a CAC rejection policy of 2 (the LCN connection is
maintained):
cnfconcacpol 131 1 2
Related Commands
Command
cnfconvbdpol
Cisco VISM Installation and Configuration Guide
5-130
cnfconcacpol lcn carrier-loss-pol cac-reject-pol
Logical channel number of the connection; in the range from 131 to 510.
Carrier loss policy. It can be one of the following values:
1 = Revert to the previous codec
•
2 = Maintain the upspeed codec
•
•
3 = Unspecified
Note
If you select 3 (unspecified), the card level default is used.
CAC rejection policy. It can be one of the following values:
•
1 = Delete the connection
2 = Maintain the connection
•
3 = Unspecified
•
If you select 3 (unspecified), the card level default is used.
Note
Description
Configures the policies for fax/modem upspeed CAC failure and fax/modem
carrier loss for calls added to a particular IP or AAL2 LCN.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
