dspcacfailcntrs
dspcacfailcntrs
To display the connection admission control (CAC) failure counters that are set to 0, use the
dspcacfailcntrs command in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Use this command for debugging purposes—to reset counters and isolate VISM CAC-related failures.
Counter values greater than 0 indicate that the gateway is low on resources.
Examples
The following example shows that the CAC failure counters that are set to 0 are displayed:
dspcacfailcntrs
PVC Addition Failures
SVC Addition Failures
VC CAC Failures for PVCs
PVC Upspeed Failures
SVC Upspeed Failures
Related Commands
Command
clrcacfailcntrs
Cisco VISM Installation and Configuration Guide
5-304
dspcacfailcntrs
Description
Resets the CAC failure counters to 0.
:0
:0
:0
:0
:0
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5
CLI Commands