Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfcasendpt
To associate an endpoint with a channel associated signaling (CAS) variant name, use the cnfcasendpt
command in the VoIP switching/trunking operating mode.
Syntax Description
endpt-num
var-name
Command Modes
VoIP switching/trunking
Usage Guidelines
The endpoint and CAS variant must be previously added before you execute this command.
If there is no connection on an endpoint when the endpoint is associated with a CAS variant, use the
cnfcasendpt command again to change the CAS variant. However, if there is a connection on an
endpoint, you must delete the endpoint, add it back, and then execute the cnfcasendpt command to
change the CAS variant.
Examples
The following example shows that endpoint number 3 is associated with the q50.o CAS variant:
cnfcasendpt 3 q50.o
Related Commands
There are no related commands.
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfcasendpt endpt-num var-name
The endpoint number which is to be associated with the CAS variant identified by the
var-name argument value. It can be a value from one of the following ranges:
•
For template number 1:
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
•
For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
•
For template number 3:
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
For template number 4:
•
For VISM-PR, from 1 to 144
–
Name of the CAS variant; a text string from 1 to 64 alphanumeric characters.
Cisco VISM Installation and Configuration Guide
cnfcasendpt
5-93
Advertisement
Table of Contents
