Table of Contents
Advertisement
dspdisctimers
dspdisctimers
To display the Restart in Progress command disconnect type method wait delay times, use the
dspdisctimers command in the VoIP switching/trunking, switched AAL1 SVC, switched AAL2 SVC,
switched AAL2 PVC, AAL2 trunking, VoIP and switched ATM AAL1 SVC operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes
VoIP switching/trunking, switched AAL1 SVC, switched AAL2 SVC, switched AAL2 PVC, AAL2
trunking, VoIP and switched ATM AAL1 SVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the Restart in Progress command disconnect type method wait delay
times are displayed:
dspdisctimers
Initial Waiting Delay: 15secs
Min Waiting Delay:
Nax Waiting Delay:
Related Commands
Command
addmgcgrpprotocol
cnfdisctimers
cnfmgcgrpprotocol
cnfxgcppeer
delmgcgrpprotocol
Cisco VISM Installation and Configuration Guide
5-336
dspdisctimers
15 secs
600 secs
Description
Associates a call agent redundancy group to a gateway control protocol.
Specifies the wait delay times for the disconnected procedure, restart in
progress command—initial, minimum, and maximum timer values.
Configures call agent group protocol data.
Configures the UDP port number used to send gateway-initiated messages to
the call agent.
Deletes an MGCP from a specified call agent redundancy group.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
