Table of Contents
Advertisement
cnfxgcpbt
cnfxgcpbt
To configure a default bearer type—if one is not specified by the call agent by the xGCP local connection
options—for the current VISM card, use the cnfxgcpbt command in the VoIP switching/trunking,
switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
network-type
vc-type
aal-conn-type
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
If the default bearer types (network, VC, or connection) are specified as part of the local connection
options, those types take precedence over the types specified in this command.
Examples
The following example shows that the current VISM card is configured for the IP network type and for
PVC:
cnfxgcpbt 1 1 3
Related Commands
Command
dspxgcpbt
Cisco VISM Installation and Configuration Guide
5-234
cnfxgcpbt network-type vc-type aal-conn-type
Network type. It can be one of the following values:
•
1 = IP
2 = ATM
•
Virtual circuit type. It can be one of the following values:
•
1 = Permanent virtual circuit (PVC)
•
2 = Switched virtual circuit (SVC)
Connection type. It can be one of the following values:
•
1 = ATM Adaptation Layer Type 1 (AAL1)
2 = ATM Adaptation Layer Type 2 (AAL2)
•
3 = Not applicable
•
You must select 3 (not applicable) if you selected a network-type
Note
argument value of 1 (IP).
Description
Displays the default network, VC, and connection types configured for the
current VISM card.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
