Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 627

Chapter 5 CLI Commands
dspxgcpport
To display the local User Datagram Protocol (UDP) port number used by the Simple Gateway Control
Protocol (SGCP) or the Media Gateway Control Protocol (MGCP), use the dspxgcpport command in
the VoIP switching/trunking operating mode.
Syntax Description
This command has no arguments or keywords.
Command Modes VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the UDP port number used by SGCP/MGCP is displayed:
dspxgcpport
xgcpPortNumber: 2427
Related Commands Command
cnfxgcppeer
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspxgcpport
Description
Configures the UDP port number used to send gateway-initiated messages to the call
agent.
Cisco VISM Installation and Configuration Guide
dspxgcpport
5-483