Chapter 5
CLI Commands
line-type
loop-detection
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
You must add the line indicated by the line-num argument value with the addln command before using
this command. You must include all argument values when using this command; however, the line-num
and clock-source arguments are the only relevant arguments for configuring the clocking source on your
VISM cards.
Examples
The following example shows that line 2 is configured with HDB3 coding, SMB E1 back card line
length, loop clocking, E1 line type, and loopback detection disabled:
cnfln 2 3 8 1 3 1
Related Commands
Command
addln
delln
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Line type. It can be one of the following values:
•
1 = DSx1ESF
2 = DSx1D4
•
3 = E1
•
4 = E1CRC
•
5 = E1MF
•
6 = E1MFCRC
•
•
7 = E1 Clear
•
8 =
•
9 =
Loopback code detection. It can be one of the following values:
1 = Disabled
•
2 = Enabled
•
Description
Adds a T1 or E1 line to a VISM card.
Deletes a DS1 line on a VISM card.
Cisco VISM Installation and Configuration Guide
cnfln
5-165