Table of Contents
Advertisement
cnfcon
cnfcon
To configure a connection between a VISM card and an MGX 8000 Series platform PXM card, use the
cnfcon command in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating
modes.
Syntax Description
lcn
peak-cell-rate
service-type
sus-cell-rate
max-burst-rate
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Cisco VISM Installation and Configuration Guide
5-126
cnfcon lcn peak-cell-rate service-type |sus-cell-rate max-burst-rate|
Logical channel number of the connection; in the range from 131 to 510.
Peak cell rate (described in cells per second). It can be a value from one of the
following ranges:
1 to 80000 for VoIP bearer
•
1 to 20000 for VoIP control
•
1 to 50000 for AAL2 T1
•
1 to 60000 for AAL2 E1
•
•
1 to 400 for AAL2 signaling (trunking)
•
1 to 90000 for AAL5 bearer
•
1 to 10000 for AAL5 control
Note
The peak-cell-rate argument value must be 15 or greater if the
service-type argument value is a variable bit rate selection.
Service type. It can be one of the following values:
1 = Constant bit rate (CBR)
•
2 = Variable bit rate real time—VBR (RT)
•
3 = Variable bit rate non-real time—VBR (NRT)
•
•
4 = VBR (RT) 3
•
5 = VBR (RT) 2
•
6 = VBR (NRT) 2
•
7 = VBR (NRT) 3
Use values 4 to 7 for VISM-PR to RPM-PR connections.
Note
(Optional) Sustainable cell rate. It can be in the range from 1 to the value you
configured for the peak-cell-rate argument value.
This argument value is required if the service-type argument value is in
Note
the range from 2 to 7.
(Optional) Maximum burst size—maximum number of cells transmitted at the
peak cell rate. It can be in the range from 1 cell to 10 times the value you
configured for the sus-cell-rate argument value.
This argument value is required if the service-type argument value is in
Note
the range from 2 to 7.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
