cnflntonetimeout
cnflntonetimeout
To modify the timeout periods of call progress tones supported by VISM on a specified VISM card line,
use the cnflntonetimeout command in the VoIP switching/trunking, AAL1 switching, switched AAL2
SVC, switched AAL2 PVC, and VoIP and switched ATM AAL1 SVC operating modes.
Syntax Description
line-num
remote-ringb-tout
local-ringb-tout
busy-tout
reorder-tout
dial-tout
stutter-tout
offhook-tout
Command Modes
VoIP switching/trunking, AAL1 switching, switched AAL2 SVC, switched AAL2 PVC, and VoIP and
switched ATM AAL1 SVC
Usage Guidelines
You can configure timeout periods of the following tones:
•
•
•
•
•
•
Note
A tone timeout argument value set to 0 indicates an infinite timeout—the tone will play indefinitely
unless it is stopped by an event.
Cisco VISM Installation and Configuration Guide
5-176
cnflntonetimeout line-num remote-ringb-tout local-ringb-tout busy-tout reorder-tout dial-tout
stutter-tout offhook-tout
Line number for which you want to modify tone timeout periods (defined in
seconds). In the range from 1 to 8.
Remote ringback tone timeout period (defined in seconds). It can be in the
range from 0 to 3600. (Default = 180)
Local ringback tone timeout period (defined in seconds). It can be in the range
from 0 to 3600. (Default = 180)
Busy tone timeout period (defined in seconds). It can be in the range from 0 to
3600. (Default = 30)
Reorder tone timeout period (defined in seconds). It can be in the range from
0 to 3600. (Default = 30)
Dial tone timeout period (defined in seconds). It can be in the range from 0 to
3600. (Default = 16)
Stutter dial tone timeout period (defined in seconds). It can be in the range
from 0 to 3600. (Default = 16)
Offhook tone timeout period (defined in seconds). It can be in the range from
0 to 3600. (Default = 5)
Ringback
Busy
Reorder (also known as the fastbusy or the network congestion tone)
Dial
Stutter dial
Offhook alert
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands