Table of Contents
Advertisement
Chapter 5
CLI Commands
dsploops
To display all lines and DS0s that are in the loopback condition, use the dsploops command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the lines and DS0s that are currently in the loopback condition are
displayed:
dsploops
Line Loopbacks on this card
---------------------------
Line 1: Local Loopback
ds0 loopbacks on this card
--------------------------
Endpoint 1 Loopback Enabled
Related Commands
Command
addconloop
addendptloop
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dsploops
Description
Configures a cellbus connection to local loopback condition on a current card.
Places an endpoint in a loopback condition in the TDM direction.
Cisco VISM Installation and Configuration Guide
dsploops
5-379
Advertisement
Table of Contents
