Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 157

Chapter 5 CLI Commands
service-type
sus-cell-rate
max-burst-rate
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines You must execute the addport and addrscprtn commands before you use this command.
If you are using this command with the VoIP switching/trunking operating mode and dual PVCs, you
must add the primary channel before the secondary channel.
If you are using this command with the AAL2 trunking operating mode, the pvc-conn-type argument
value must be 1 (AAL5) for signaling and 2 (AAL2) for a bearer channel.
This command requires you to configure the PVC connections in the following ways for the different
operating modes:
•
•
•
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
(Optional) Service type. It can be one of the following values:
• 1 = Constant bit rate (CBR)
2 = Variable bit rate real time, VBR (RT)
•
3 = Variable bit rate non-real time, VBR (NRT)
•
4 = VBR (RT) 3
•
5 = VBR (RT) 2
•
6 = VBR (NRT) 2
•
• 7 = VBR (NRT) 3
Note Use value 7 for VISM-PR to RPM-PR connections.
(Optional) Sustainable cell rate (defined in cells per second). It can be in the
range from 15 to the value you configured for the peak-cell-rate argument value.
Note This argument value is required if the service-type argument value is in
the range from 2 to 7.
(Optional) Maximum burst size—maximum number of cells transmitted at the
peak cell rate. It can be in the range from 1 cell to 10 times the value you
configured for the sus-cell-rate argument value.
Note This argument value is required if the service-type argument value is in
the range from 2 to 7.
VoIP switching/trunking operating mode addcon command configuration requirements:
– One AAL5 PVC connection with an optional secondary AAL5 PVC connection.
AAL2 trunking operating mode addcon command configuration requirements:
– One AAL2 connection and up to 63 additional optional AAL2 connections to each remote
location.
– Up to eight AAL5 connections for CCS signaling across the trunk, if your application requires
CCS.
Switched AAL2 PVC operating mode addcon command configuration requirements:
– One AAL2 connection.
– One AAL5 connection for communication with the call agent and external DNS.
Cisco VISM Installation and Configuration Guide
addcon
5-13