Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 184

addrudptrunk
addrudptrunk
To add an ISDN PRI backhaul Reliable User Datagram Protocol (RUDP) session for a Link Access
Protocol D channel (LAPD) trunk connection, use the addrudptrunk command in the VoIP
switching/trunking operating mode.
Syntax Description
session-num
lport-num
rport-num
remote-ip-addr
Command Modes
VoIP switching/trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples
The following example shows that the ISDN PRI backhaul RUDP session number 40 is added to the
LAPD trunk connection with local port 1024, remote port 2006, and remote IP address 209.165.200.244:
addrudptrunk 40 1024 2006 209.165.200.244
Related Commands Command
addlapdtrunk
addrtpcon
clrrtpcnt
cnflapdtrunkpvc
cnflntrunkcond
cnfrtpcon
cnfrudptrunkrmtip Modifies the remote IP address of VISM used in the ISDN PRI backhaul RUDP
dellapdtrunk
delrtpcon
delrudptrunk
dsplapd
dsplapdtrunkpvc
dsplapdtrunks
Cisco VISM Installation and Configuration Guide
5-40
addrudptrunk session-num lport-num rport-num remote-ip-addr
Identifying session number in the range from 1 to 64.
Local port number. It can be in the range from 1124 to 49151.
Remote port number. It can be in the range from 1124 to 49151.
IP address of the remote VISM card, in dotted decimal format
(nnn.nnn.nnn.nnn).
Description
Adds an LAPD trunk to a specific VISM card line.
Adds a static RTP VoIP trunking connection.
Clears the RTP counters (statistics) for a specific static RTP connection.
Assigns the PVC trunk type that carries LAPD messages for the current VISM
card.
Enables or disables line conditioning on a VISM card line if a network alarm
is encountered.
Modifies an existing static RTP VoIP trunking connection.
trunk for a specified session.
Deletes an LAPD configured line.
Deletes a static RTP VoIP trunking connection.
Deletes an ISDN PRI backhaul RUDP session that is associated with an LAPD.
Displays data about an LAPD.
Displays the assigned PVC trunk type that carries LAPD trunk messages for
the current VISM card.
Displays the configuration data of all LAPD trunks.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands