Table of Contents
Advertisement
addrtpcon
addrtpcon
To add a static Real-Time Transport Protocol (RTP) VoIP trunking connection, use the addrtpcon
command in the VoIP switching/trunking operating mode.
Syntax Description
conn-num
endpt-num
local-rtp-port
remote-rtp-port
remote-ip-addr
Cisco VISM Installation and Configuration Guide
5-36
addrtpcon conn-num endpt-num local-rtp-port remote-rtp-port remote-ip-addr codec-type
|vt-pkt-period bearer-prec bearer-tos conn-mode ecan-enable vad-enable vad-timer cas-trans
dtmf-trans idle-code-sup|
Connection identification number. It can be in the range from 1 to 248.
Endpoint number. It can be a value from one of the following ranges:
For template number 1:
•
–
–
–
•
For template number 2:
–
–
•
For template number 3:
–
–
–
For template number 4:
•
–
Static RTP local port number. It can be an even number in the range from 49648
to 50142.
Note
Static RTP remote port number. It can be an even number in the range from
16384 to 50142.
Note
IP address of the remote VISM card, in dotted decimal format
(nnn.nnn.nnn.nnn).
For VISM, from 1 to 145
For VISM-PR T1, from 1 to 192
For VISM-PR E1, from 1 to 248
For VISM T1, from 1 to 192
For VISM E1, from 1 to 248
For VISM, from 1 to 120
For VISM-PR T1, from 1 to 192
For VISM-PR E1, from 1 to 248
For VISM-PR, from 1 to 144
The odd numbers within the local-rtp-port range are reserved for
Real-Time Conferencing Protocol (RTCP) ports.
The odd numbers within the remote-rtp-port range are reserved for
RTCP ports.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
