Table of Contents
Advertisement
Chapter 5
CLI Commands
addmgcgrpprotocol
To associate a call agent redundancy group with a gateway control protocol (xGCP) and configure call
agent group protocol control data, use the addmgcgrpprotocol command in the VoIP switching/trunking
and switched AAL2 PVC operating mode.
Syntax Description
red-mgc-group
protocol-num
quar-persist
default-quar
del-negated
prov-resp
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
addmgcgrpprotocol red-mgc-group protocol-num quar-persist default-quar del-negated prov-resp
resp-ack disc-proc-enable cancel-grace
Call agent redundancy group number. It can be in the range from 1 to 8.
Protocol number. It can be one of the following values:
•
•
•
•
•
(Optional) Sets the quarantine handling method for persistent events. It can
be one of the following values:
•
•
(Optional) Sets the default quarantine handling method for each protocol. It
can be one of the following values:
•
•
•
•
Note
(Optional)
•
•
(Optional) Enables or disables the sending of a provisional response. It can
be one of the following values:
1 = On (Default for MGCP 1.0)
2 = Off (Default for MGCP 0.1, SGCP 1.1+, SRCP 1.0.2, and SGCP 1.5)
1 = MGCP 0.1
2 = SGCP 1.1+
3 = SRCP 1.0.2
4 = SGCP 1.5
5 = MGCP 1.0
1 = Quarantine persistent events (Default)
2 = Do not quarantine persistent events
1 = Step, process (Default for MGCP 1.0)
2 = Step, discard (Default for MGCP 0.1, SGCP 1.1+, SRCP 1.0.2, and
SGCP 1.5)
3 = Loop, process
4 = Loop, discard
Step = one notification command is generated per notification
request. Loop = multiple notification commands are generated per
notification request.
1 = Delete events from the previous list which are not present in the
current list.
2 = Delete events from the previous list, only if the event is present in
the current list with a hyphen (-) as the parameter.
Cisco VISM Installation and Configuration Guide
addmgcgrpprotocol
5-31
Advertisement
Table of Contents
