Table of Contents
Advertisement
dsptoneplan
dsptoneplan
To display the tone configuration of a specified tone plan—either a built-in (preconfigured) or a
provisional tone plan—use the dsptoneplan command in the VoIP switching/trunking and switched
AAL2 PVC operating modes.
Syntax Description
tonep-region
tonep-version
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
This command displays amplitudes as a number which corresponds to a dBm value according to the
following formula:
This formula equals the amplitude of one frequency. If both frequencies are configured for the same
level, add 6 dBm to the results of the formula to obtain the total amplitude.
Examples
The following example shows that the tone configuration for singapore tone plan region, version number
11, is displayed:
dsptoneplan singapore 11
Region Name :Singapore
Version: 1
Description: Tone Plan for Singapore (SG)
File name: BUILTIN
Related Commands
Command
addtoneplan
cnflnringback
cnflntoneplan
cnflntonetimeout
dellntoneplan
deltoneplan
dsplnringback
Cisco VISM Installation and Configuration Guide
5-444
dsptoneplan tonep-region tonep-version
Tone plan country or region for which you want to display the tone
configuration. It can be in the range from 1 to 64 alphanumeric characters and
can contain underscores ( _ ). This value is case sensitive.
Tone plan version number of the tone plan country or region for which you
want to display the tone configuration. It can be in the range from 1 to 65535.
dBm = 20 * log10 (peek-to-peek/46348)
Description
Adds a tone plan to the current VISM card.
Configures the ringback tone method for a specified line on the current VISM
card.
Assigns a tone plan to a specified VISM card line.
Modifies the timeout periods of all call progress tones supported by VISM on
a specified VISM card line.
Deletes the tone plan configuration of a specified VISM card line.
Deletes a previously added tone plan from the current VISM card.
Displays the ringback tone method for a specified line on the current VISM
card.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
