Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 473

Chapter 5 CLI Commands
dspcodectmpls
To display all entries in the codec template table, use the dspcodectmpls command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
VISM maintains a table of codec templates; each entry in the table contains the following:
•
•
•
Examples
The following example shows that all entries in the codec template table are displayed:
dspcodectmpls
codecTemplateNumber
-------------------
Related Commands Command
cnfcodectmpl
dspcodecparams
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspcodectmpls
Codec template number
Codecs supported
Maximum number of DS0s supported by the template
codecSupported
--------------
1
2
3
Description
Assigns a codec template to a VISM card.
Displays codec parameters.
MaxChanCount
------------
0x1ff 145
0x23 192
0x1ff 120
Cisco VISM Installation and Configuration Guide
dspcodectmpls
5-329