Table of Contents
Advertisement
delrtpcon
delrtpcon
To delete a static Real-Time Transport Protocol (RTP) VoIP trunking connection, use the delrtpcon
command in the VoIP switching/trunking operating mode.
Syntax Description
conn-num
Command Modes
VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the static RTP connection number 200 is deleted:
delrtpcon 200
Related Commands
Command
addlapdtrunk
addrtpcon
addrudptrunk
clrrtpcnt
cnflapdtrunkpvc
cnflntrunkcond
cnfrtpcon
cnfrudptrunkrmtip Modifies the remote IP address of VISM used in the ISDN PRI backhaul RUDP
dellapdtrunk
delrudptrunk
dsplapd
dsplapdtrunkpvc
dsplapdtrunks
dsprtpcnt
dsprtpcon
dsprtpconnstat
dsprtpcons
Cisco VISM Installation and Configuration Guide
5-268
delrtpcon conn-num
Connection identification number. It can be in the range from 1 to 248.
Description
Adds an LAPD trunk to a specific VISM card line.
Adds a static RTP VoIP trunking connection.
Adds an ISDN PRI backhaul RUDP session for an LAPD trunk connection.
Clears the RTP counters (statistics) for a specific static RTP connection.
Assigns the PVC trunk type that carries LAPD messages for the current VISM
card.
Enables or disables line conditioning on a VISM card line if a network alarm
is encountered.
Modifies an existing static RTP VoIP trunking connection.
trunk for a specified session.
Deletes an LAPD configured line.
Deletes an ISDN PRI backhaul RUDP session that is associated with an LAPD.
Displays data about an LAPD.
Displays the assigned PVC trunk type that carries LAPD trunk messages for
the current VISM card.
Displays the configuration data of all LAPD trunks.
Displays the bearer counters (statistics) for a specified RTP VoIP trunking
connection.
Displays the configuration data of a specified static RTP VoIP trunking
connection.
Displays the RTP connection statistics for a specified endpoint.
Displays the configuration data of all static RTP VoIP trunking connections.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
