dspt38params
dspt38params
To display the T.38 fax transfer parameters for a specified line, use the dspt38params command in the
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
line-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the T.38 fax transfer parameters for line 7 are displayed:
dspt38params 7
line_number:
Max_Xmit_Rate:
Info_Field_Size:
Data_Pkt_size:
LS_Data_Redundancy: 5
HS_Data_Redundancy: 2
TCF_Method:
Error_Correction:
NSF_Override:
NSF_Country_Code:
NSF_Vendor_Code:
Related Commands
Command
cnfcodectmpl
cnft38fxlco
cnft38nsetimeout
cnft38params
dspcodectmpls
dspt38fxlco
dspt38fxlcos
dspt38nsetimeout
dspt38nsetimeouts
Cisco VISM Installation and Configuration Guide
5-440
dspt38params line-num
Line number of the DS1 line for which you want to display T.38 fax transfer
parameters. It can be in the range from 1 to 8.
7
fx14400bps
48
40 ms
localTCF
enabled
enabled
181
18
Description
Assigns a codec template to an entire VISM card.
Configures the fax handling instructions for a specified line.
Configures a specified line with a length of time in which to wait for a remote
acknowledgment of the offer to switch to fax transfer mode.
Configures the T.38 fax transfer parameters for a specified line.
Displays all entries in the codec template table.
Displays the fax handling instructions configured for a specified line.
Displays the fax handling instructions for all lines on the current VISM card.
Displays a specified configured line with a length of time in which to wait for
a remote acknowledgment of the offer to switch to fax transfer mode.
Displays all configured lines with a length of time in which to wait for a remote
acknowledgment of the offer to switch to fax transfer mode.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands