Table of Contents
Advertisement
cnfmusicthreshold
cnfmusicthreshold
To configure the music on-hold threshold value for the current VISM card, use the cnfmusicthreshold
command in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
music-thresh
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
This command allows you to adjust the threshold level detected by DSPs to interpret TDM side silence
or voice.
Examples
The following example shows that the current VISM card is configured with a –45-dB music on-hold
threshold value:
cnfmusicthreshold -45
Related Commands
Command
cnfds0musicthreshold
cnflnmusicthreshold
dspds0musicthreshold
dsplnmusicthreshold
dspmusicthreshold
Cisco VISM Installation and Configuration Guide
5-186
cnfmusicthreshold music-thresh
Music on-hold threshold (defined in decibels). It can be in the range from
–70 to –30.
Description
Configures the music on-hold threshold for a specified DS0.
Configures the music on-hold threshold for all DS0s on a specified line.
Displays the music on-hold threshold value for a specified DS0.
Displays the music on-hold threshold values for the DS0s on a specified
line.
Displays the music on-hold threshold values for the current VISM card.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
