Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfrsvp
To configure Resource Reservation Protocol (RSVP) for a specified connection, use the cnfrsvp
command in the VoIP switching/trunking and VoIP and switched ATM AAL1 SVC operating modes.
Syntax Description
lcn
rsvp-enable
Command Modes
VoIP switching/trunking, VoIP and switched ATM AAL1 SVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that RSVP is enabled for LCN 146:
cnfrsvp 146 1
Related Commands
Command
cnfrsvprefreshmiss
dsprsvpif
dsprsvpreq
dsprsvpreqs
dsprsvpresv
dsprsvpresvs
dsprsvpsenders
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfrsvp lcn rsvp-enable
The logical channel number. It can be in the range from 131 to 510.
Enables or disables RSVP. It can be one of the following values:
1 = On
•
•
2 = Off
Description
Configures the number of times VISM waits for a missed RSVP minimum
refresh message for a specified connection.
Displays the RSVP status of a specified connection.
Displays the data associated with a specified RSVP request.
Displays all RSVP-known requests on the current VISM card.
Displays all data associated with an RSVP bandwidth reservation.
Displays all incoming RSVP-known reservations on the current VISM card.
Displays all data associated with a specified RSVP path state.
Cisco VISM Installation and Configuration Guide
cnfrsvp
5-195
Advertisement
Table of Contents
