Table of Contents
Advertisement
Configuring VISM Features
aal-conn-type:
•
–
–
–
Note
Step 5
Type the addxgcppersistevt command, event-num and pkg-event argument values, and press Enter to
designate xGCP events as persistent.
Note
Specify the arguments with the following values:
event-num: In the range from 1 to 64.
•
pkg-event:
•
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
Type the cnfsrcppeer command, peer-num and udp-port-num argument values, and press Enter to
Step 6
specify the SRCP parameters for communication between VISM and the call agent. Specify the
arguments from the following values:
peer-num: The peer (call agent) identification number, as displayed in the dspsrcppeers command
•
list; in the range from 1 to 8.
udp-port-num: In the range from 1025 to 65535
•
Note
Cisco VISM Installation and Configuration Guide
4-48
1 = AAL1
2 = AAL2
3 = Not applicable
You must type 3 for the aal-conn-type argument if the network-type argument = 1.
Do not complete this step if persistent events are not required for your application.
r/co3 = VISM initiated AAL2 type 3 packet (CO3) network continuity test
r/co4 = Network continuity test detect
g/ft = Fax tone
g/mt = Modem tone
g/vbd = Voiceband data
g/vbdt = Voiceband data termination
l/hu, bl/hu = On hook
l/hd, blhd = Off hook
ms/ans, dt/ans, md/ans, mo/ans = Answer
ms/sup, dt/sup, md/sup = Setup
ms/rel, dt/rel, md/rel, mo/rel = Release
ms/rtc, dt/rlc, md/rlc, mo/rlc = Release complete
ms/res, dt/res, md/res = Resume
ms/sus, dt/sus, md/sus = Suspend
md/awk = Acknowledgment wink
mo/rbz = Reverse make busy
If you do not execute this command, the default MGCP/SGCP port number = 2428.
Chapter 4
Configuring VISM Features
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Advertisement
Table of Contents
