Table of Contents
Advertisement
dspmgcgrpparams
dspmgcgrpparams
To display all configured Media Gateway Control Protocol (MGCP)—call agent—redundancy group
parameters, use the dspmgcgrpparams command in the VoIP switching/trunking and switched AAL2
PVC operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that all configured call agent redundancy group parameters are displayed:
dspmgcgrpparams
Mgc Grp Num
-----------
Related Commands
Command
addmgcgrpentry
addmgcgrpprotocol
cnfmgcgrpparam
cnfmgcgrpentry
cnfsrcppeer
cnfsrcppeergrpparam
delmgcgrpentry
delmgcgrpprotocol
dspmgcgrpprotocols
dspmgcgrps
dspsrcppeergrpparams
Cisco VISM Installation and Configuration Guide
5-382
dspmgcgrpparams
Com State
State Chg Notification
---------
----------------------
1
CommLoss
Description
Configures call agents as part of an MGC redundancy group and assigns a
priority value for a call agent.
Associates a call agent redundancy group to a gateway control protocol.
Modifies a call agent redundancy group state change notification policy
and priority level.
Modifies the call agent priority level of a call agent within a call agent
redundancy group.
Configures the SRCP parameters when SRCP is the selected protocol for
communication between the VISM card and call agent.
Modifies the SRCP heartbeat interval and maximum UDP size for a
specified call agent redundancy group.
Deletes a call agent from a call agent redundancy group.
Deletes an MGCP from a specified call agent redundancy group.
Displays all configured call agent redundancy group protocols.
Displays all configured call agent redundancy groups.
Displays the SRCP parameters for all call agent redundancy groups that
have SRCP added.
Priority
--------
Enabled
1
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5
CLI Commands
Advertisement
Table of Contents
